The MM443 is a programmable logic controller (PLC) with four analog or digital inputs and four relay outputs. It may be used as a stand alone controller in a vast array of applications from timers, door controllers, simple process controllers, multiple zone security controls, etc. or as a networked controller with up to 31 other modules connected on a common RS-485 data bus. The Magic Module supports transmitting and receiving commands from two way X-10® Power Line Carrier Devices. Also optional interfaces are available for reading Temperature, Clock/Calendar, Wiegand Proximity devices, Dallas iButton™ identification devices, and can be interfaced to Caddx NX Security Controls. The Magic Module is programmed by a personal computer. The program is stored into reprogrammable Electrically Erasable Programmable Read Only Memory (EEProm memory). The ELK Starter Kit (ELK-MK400) or Programming Kit (ELKMK485) contains components and software needed to program the Magic Module™.
FEATURES:
• Four analog or digital inputs.
• Four relay outputs (2 relay outputs may be jumper programmed for transistor open collector outputs).
• 16,384 program bytes using SIMPLE programming language.
• 4 general purpose Counters, range 0 to 255 counts.
• 4 general purpose Timers, range 1/10 second to over 255 hours.
• Networked to optional PC and up to 31 ELK-MM443’s through a RS-485 data bus.
• X-10® Power Line Carrier Interface. PL513, PSC04 (Transmit Only), or TW523, PSC05 (Two Way).
• Analog transmission MM443 to MM443 and Preset Dim Commands.
• Dallas iButton™ TouchKey Reader with optional ELK-MA100 or ELK-MA290 interface.
• Programs the ELK-MM220 (two inputs, two relay outputs).
• Emulates ELK-MM220 for code development.
• Program stored in non-volatile EEProm memory.
• Mounts to single or double gang electrical box.
• Optional DIN Rail Mounting. PCB mounts into 4 inch SnapTrack.
• Lifetime Limited Warranty. Magic Module™ Programmable Controller ELK-MM443 F
SPECIFICATIONS:
• Inputs: 4 analog, 0 to 13.6 volts, with jumper programmable 2k pull up resistor to 12V, or 2k pull down resistor toground. May be left floating. Software programmable high and low threshold levels per input for end-of-line resistor circuits. Input impedance (floating input) - 100k ohms.
• Outputs: 4 Form “C” relays, 10 Amps @ 120 VAC or 7 Amps @ 28 VDC. Two relay outputs may be configured as open collector transistor outputs - 100 mA Max.
• Operating Voltage: 9.5 - 15 Volts D.C.
• Current Draw: 10mA Nominal, 130mA Maximum with all relays active.
• X-10® Interface: PL513, PSC04 or TW523, PSC05 - 4 wire RJ-11 telephone style.
• Data Bus: RS-485, max bus length - 4000 feet w/22 AWG wire.
• Enclosure: White plastic, 6.5”W x 4.375”H x 2”D.
Product Code: ELK-MM443
